리퍼비시 계측기
In Autotest mode the CTS60 is easy and convenient to operate thanks to its clear menu structure.
If this is your first encounter with CTS60 in Autotest mode, this chapter will give you a quick survey of
configuring and running an automatic test.
The autotest enables fixed and portable part tests to be configured as required. The test are stored on
the CTS60 and can be selected and run at a future date. There are 10 configurable tests for both fixed
and portable part tests. Each of these tests can comprise up to 50 test steps. Conditional and
unconditional jumps can also be used to configure longer tests.
The following is a list of the possible actions which can be configured for a test step:
• Free – no action has been assigned to this test step (default value)
• Setup connection – set up a connection with a fixed or portable part depending on the test menu
selected
• Power Ramp – perform a single power ramp measurement
• RF Modulation – perform an RF modulation measurement
• Timing – perform a timing measurement
• Bit Error Rate – perform a bit error rate measurement
• Bearer Release – release an established connection
• Pause – pause during an autotest
Condensed data of Digital Radio Testers CTS
GSM mode (CTS55/65) DECT mode (CTS60/65)
DUTs GSM900, GSM1800, FPs and PPs for DECT Europe
GSM1900 mobile phones and DECT Latin America
Modes quick test, loopback mode,
manual test, manual test,
auto test, auto test,
module test, remote control via RS-232-C
remote control via RS-232-C
Functions synchronization, synchronization,
location update, call setup call setup and release,
and release, handover, echo test
power change, echo test
Test parameters power, power ramp, power, power ramp,
phase/frequency error, demodulated frequency/offset/drift,
timing accuracy, sensitivity modulation deviation, timing
(BER, RBER, FER, RxLev, accuracy, jitter, packet a timing accuracy,
RxQual) sensitivity (BER, FER)
K6: Remote Control